Maduino Zero WiFi ESP8266 v1.6

From MakerFabsWiki
Jump to: navigation, search

Introduction

Maduino Zero ESP8266 is an IoT (Internet of things) Solution based on the 32-bit Atmel’s SAMD21 MCU and WiFi module ESP8266. It integrated a micro Controller ATSAMD21G18, WiFi module ESP8266. The Maduino Zero ESP8266 based on the Arduino, users can program it with Arduino IDE, which is very easy especially suit for the none-programmers. There are also guide for users to learn how to create the first IoT project with this board, with which the starters can learn the hardware and programming skill quickly. With this board, you will easy to add text, SMS, and data to your project. It is good for your smart home project or M2M and so on.

Model: OAC8266ES
Maduino Zero WiFi ESP8266 1.jpg

Features

  • BAT Input Voltage: 3.4-4.2V
  • ATSAMD21G18, 32-Bit ARM Cortex M0+
  • Integrated Power Control System
  • Support AT Command
  • Support USB Power Charge
  • Support Micro SD Card
  • Interface: I2C/SPI/UART/18*GPIO
  • Arduino Compatible
  • Working Temperature: -40 – 85℃
  • Size: 40mm*55mm


Usage

Project_1 WIFI

1. Connect

Plug in a USB cable or a 3.7v lithium battery, Turn on the switch.
Maduino Zero WiFi ESP8266 3.jpg


2. Download

Download and open the Serial_WIFI_v1.0.ino
Select the board Arduino/Genuino Zero(Native USB Port) and the corresponding Port

Maduino Zero WiFi ESP8266 4.jpg

modify the SSID and PASSWORD to your WIF and password:

#define SSID "Makerfabs"  // your ssid
#define PASS "20160704"   //pass word

Then click to download

Maduino Zero WiFi ESP8266 11.jpg


Open the serial port tool and view the printed IP address

Maduino Zero WiFi ESP8266 6.jpg

Note: Maduino Zero WiFi ESP8266 v1.6 will print a piece of scrambled code after power, which is a normal phenomenon.


3. Show

Open the browser and enter the IP address after '+CIFSR:STAIP '
The page will display the 'makerfabs '

Maduino Zero WiFi ESP8266 7.jpg

Finally, wait for the module to finish executing the AT+RESTORE command to RESTORE factory Settings:

Maduino Zero WiFi ESP8266 9.jpg

Project_2 Basic test of SD card

Insert SD card, plug in a USB cable or a 3.7v lithium battery. Turn on the switch.
Maduino Zero WiFi ESP8266 2.jpg


Download and open the Serial_SD_v1.0.ino
The following information can be seen in the serial port to prove that the SD card function is OK.

Maduino Zero WiFi ESP8266 8.jpg


If the SD card is not inserted, or the SD card is abnormal, the following information can be seen:

Maduino Zero WiFi ESP8266 12.jpg

FAQ

You can list you question here or contact with support@makerfabs.com for technology support. A detailed descriptions of your question will be helped to solve your question.

Resources